Call now to get tree help including tree cleanup, tree contractor, bush pruning, shrub grind, stump dig and many others across United States.


Call now

Call now +1 (855) 280-15-30






BONUS: We are sending a small packet of special silicone.

Log in Register.

Search forums. Sep 12, Home › Tree pruning burlington ma › Ask A Member › Shift rod bushing removal tool This topic has 3 replies, 3 voices, and was last updated 2 years, 11 months ago by david-bartlett.

Currently, there are 0 users and 1 guest visiting this topic. I ordered a few parts off of the parts diagram for my 6hp Johnson. Sep 15, Re: Removal Tool For Shift Rod Bushing I used a 5/16" rod cut from my kids old crib. Ground one end down to a 1/4" taper and it has worked everytime. No need to trash the bushing. And even if you do thread the bushing it will still work. The only thing it is doing is holding the O ring in. The condition of the bushing is not that bushcutter.buzzted Reading Time: 7 mins.

Jun 04, 1. Shift rod clip tool; 2. Bushing removal and installation tool; 3. 2 new nylon bushings - (comes with a pouch of synthetic grease) 4. PDF Instructions; White bushing measures: (In the groove) mm OD, mm ID, width mm. Here is what happens to these bushings when stump grinder millbrook, 77868 Navasota TX get old and tired Estimated Reading Time: 4 mins. The Sierra Shift Shaft Bushing Tool is interchangeable with the following: GLMMercury T,T,Each Sierra product meets or exceeds the original equipment part it replaces.

Sierra Shift Shaft Bushing Tool. Meets or exceeds the original equipment quality. Sierra part number: /5(13). Bushing for shift rod? You will need the Nylon bush and locking ring. cheers LEE in Australia. Logged -- Helping keep Autostick beetles on the road -- Silver metallic single port Beetle - with BOSCH SVDA and new BROSOL H30/31 carburetor with GENIE Extractor exhaust system with a quiet thunderbird muffler.

Very often it is quicker, easier, and cheaper to just buy a new 30 USD shift cover as it comes with the oring installed. Also inspect the shift rod for pitting and corrosion in the area that wipes against the o-ring. If it is rough feeling, then it will tear the new o-ring after a short time.

_____ possessing more tools than talent! Rod, Seal, Rod, Shoes, Spring, Brush, Alternator, Brush, Generator, Bulb, Light, to Bumper Bracket, Bumper, Front, Bushing Carburetor Throttle Shaft, 74 Clutch Shaft, Combine Slip Clutch, Corn Head, Front Axle Pivot, Hydraulic Pump, Hydraulic Pump Drive Plate, Link Pin Adaptor,