Whiteline Front Upper Control Arm Bushing Kit ( Jeep Wrangler TJ)Upper Control Arm Bushing ( Jeep Wrangler TJ)(1) Teraflex Small Front Upper Adjustable Control Arm Joint Rebuild Kit; Frame End ( Jeep Wrangler TJ & JK) /5(5).
Apr 19, Made a relief cut so the outter sleeve could be folded in, to release the outward pressure. Then punched it out with a nail puller (only thing I had the same width as the bushing).
For the install, go ahead and rent a ball joint press if u don't have one (or a good size c clamp) It wasrefundable at my local bushcutter.buzzted Reading Time: 3 mins. The Prothane Front Control Arm Bushing Kit is a one-stop shop to rebuild your Wrangler JK stock control arms. This kit includes new poly bushings, sleeves and grade bolts. Whether you are overhauling, restoring or chasing down the ever present clunking noises, these kits will tighten up the body and suspension and last longer in the process.
Jan 23, Jeep Wrangler JK Front control arm bushings 4/DEC/12 BRH Rev.2 10/MAR/VIA CALLEJON, SAN CLEMENTE, CA In order to remove the passenger side upper control arm, the exhaust pipe must be removed for clearance to remove the O.E.
bolt. Or you can cut the head off the bolt with a hacksaw to Upper. RockJock4x4/Currie Enterprises - N. Tustin Ave., Anaheim, Ca. Ph- F- bushcutter.buzz 6. On the rear upper control arm brackets, remove the front clip that holds the ABS sensor wire on. JEEP JK FRONT AXLE SIDE UCA MOUNT INSTALLATION INSTRUCTIONS DOC NO. INST PAGE 7 OF 7 Figure 8. Bushing Correctly Installed 8. Re-install front upper control arm. 9. Remove left side front upper control arm.
Remove factory bushing from mount cast into differential housing. It may be easiest to use an air hammer to remove. Remove the front upper control arms (one arm at a time!!!!) and replace them with the new arms included in the kit using the factory bolts. It is necessary to cut the passenger side upper control arm bolt at the frame, new ½” bolts are supplied for replacement (may be necessary to drill out the upper control arm mount with 1/2" drill). loosen both ends of the lower control arm and remove.
part# k & up jeep wrangler jk inch lift (2) lca-f front lower control arms (2) uca-f front upper control arms (2) lca-r rear lower control arms (2) uca-r rear upper control arms jeep control lengths 3” lift ” lift control arm w/ccb w/o ccb control arm w.